- October 4th, 2023, 11:44 am#4986252
Had these goggles sitting on my bench for about 5 months.....Guess it was time to finally finish them.
Gonna start off by saying that I used these files to print the parts, and sadly I dont have the link to were I bought the thumb screws.
https://www.thingiverse.com/thing:4055803
I first printed up resin lenses....but they ended up being a bit too brittle. SO I just FDM printed 2 more.
And with the last set I made.
Thankfully I can just use the same head strap between goggles. So no need to make a 2nd one
Gonna start off by saying that I used these files to print the parts, and sadly I dont have the link to were I bought the thumb screws.
https://www.thingiverse.com/thing:4055803
I first printed up resin lenses....but they ended up being a bit too brittle. SO I just FDM printed 2 more.
And with the last set I made.
Thankfully I can just use the same head strap between goggles. So no need to make a 2nd one
- By mrmichaelt
- By Mercifull
- By alphabeta001
- By smrtazzsmrtgnnr