- March 4th, 2020, 4:14 am#4932042
Am i missing a tutorial on this site? Getting the wires in the end barrel i cant figure out.
obiwanjabroni wrote: ↑July 9th, 2021, 12:36 pm You'll have to trace/measure the graph itself, then file the opening to fit with bastard file, or something similar. That is what I did with mine and I believe many others did the same.Quite literally exactly how I fit mine. Also remember to check the orientation on your Bargraph when you do mount it, it should end up with a 180 twist to the ribbon cable that connects it to the main board.
If you are using the Spongeface bezel kit, measure to the bezel. Just be sure not to go too big, just a little bit at a time. Take your time with it and you'll be good to go.
I cut out the middleman and sprayed my pack and ba[…]
I'm hoping we'll see another set when the next F[…]