User avatar
By Gatchigirl
#4967748
I decided to go a different route with my Ecto Goggles. I looked up the AN/PVS-5a Night Vision goggles and noticed that the knobs on the side were different than what was used on the prop. So I went and made my own and just need some cleanup after I 3D printed them. Here's a couple of photos. Image and Image
ccv66 liked this

    Using rip-stop cotton and custom dye for each char[…]

    The journey from commonplace to Ecto-75.

    Whole car is great but the pack trolly...how?

    Proton Props???

    If anyone here is still pondering ordering from th[…]

    I haven't done the new update to the Spirits Unlea[…]